Hyundai Santa Fe: Fuel Line. Repair procedures
Removal
| 1. |
Turn the ignition switch OFF, and then remove battery (-) cable.
|
| 2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in
Fuel Line”)
|
| 3. |
Disconnect the low pressure fuel quick-connector (A).
|
| 4. |
Disconnect the vapor hose (A) which is connected from the PCSV.
|
| 5. |
Lift the vehicle.
|
| 6. |
Remove the fuel tank.
(Refer to Fuel Delivery System - " Fuel Tank")
|
| 7. |
Disconnect the vapor tube quick-connector (A).
|
| 8. |
Open the vapor tube and low fuel line fixing clip to using driver.
|
| 9. |
Release the under cover (A) after remove the mounting bolts.
|
| 10. |
Disconnect the fuel & brake line protect (A) from the fixing clip.
|
| 11. |
Disconnect the fuel line fixing bracket (A) to engine room low.
|
| 12. |
Remove the fuel line.
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...
Filler-Neck Assembly. Repair procedures
Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation tube quick-connector ( B). 4. Open the fuel filler door and unfasten the filler-neck assembly mounting ...
See also:
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds. 2. Release ...
High Pressure Fuel Pump. Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair ...
Rear Assist Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
