Hyundai Santa Fe: Floor mat anchor(s)

When using a floor mat on the front floor carpet, make sure it attaches to the floor mat anchor(s) in your vehicle. This keeps the floor mat from sliding forward.
WARNING
The floor mat must be properly anchored so that it will not interfere with the operation of the accelerator pedal. Any interference with the accelerator pedal could cause the accelerator pedal to be unable to return to the idle position. A pedal that cannot return to the idle position could lead to an accident which may result in severe personal injury or death.
WARNING
The following must be observed when installing ANY floor mat to the vehicle, so that it will not interfere with the pedal.
- Ensure that the floor mats are securely attached to the vehicle’s floor mat anchor(s) before driving the vehicle.
- Do not use ANY floor mat that cannot be firmly attached to the vehicle’s floor mat anchors.
- Do not stack floor mats on top of one another (e.g. all-weather rubber mat on top of a carpeted floor mat). Only a single floor mat should be installed in each position.
IMPORTANT – Your vehicle was manufactured with driver’s side floor mat anchors that are designed to securely hold the floor mat in place. To avoid any interference with pedal operation, HYUNDAI recommends that only the HYUNDAI floor mat designed for use in your vehicle be installed.
Clothes hanger
To use the hanger, pull down the upper portion of hanger. CAUTION Do not hang heavy clothes, because it may damage the hook. ...
Aux, USB and iPod® port
If your vehicle has an aux and/or USB(universal serial bus) port or iPod® port, you can use an aux port to connect audio devices and a USB port to plug in a USB, or use the HYUNDAI accessory iPod® cable ...
See also:
Components and Components Location
Components [M/T] 1. Front console garnish [LH] 2. Front console garnish [RH] 3. Console upper cover 4. Ash tray 5. Console rear complete assembly 6. Console front complete assembly 7. Console side cover ...
Alternator. Components and Components Location
Components 1. OAD (Overrunning Alternator Decoupler) 2. Front bracket 3. Front bearing 4. Rotor 5. Rear bearing 6. Rear bracket 7. Through bolt 8. Regulator assembly 9. Regulator bolt 10. Rear cover ...
Sunvisor. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
