Hyundai Santa Fe: Front Door Latch. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe: Front Door Latch. Repair procedures

Replacement

1.
Remove the front door module.
2.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

3.
Open the front door outside handle cable cap (A).
4.
Remove the front door outside handle cable (B).
5.
Disconnect the front door latch connector (B).
6.
Remove the front door latch assembly (A) by pulling it.
7.
Remove the front door inside handle cable (A) by pulling it.
8.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

Front Door Latch. Components and Components Location
Component Location 1. Front door latch ...

Front Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the front door trim. 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

See also:

Infant or small child
All 50 states have child restraint laws. You should be aware of the specific requirements in your state. Child and/or infant seats must be properly placed and installed in the rear seat. For more information ...

Filter inspection
If the vehicle is operated in the severely air-polluted cities or on dusty rough roads for a long period, it should be inspected more frequently and replaced earlier. When you, the owner, replace the climate ...

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. 3. Disconnect the body control module connectors (A). 4. Remove the body control module (A) after loosening ...