Hyundai Santa Fe: Front Door Side Weatherstrip. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe: Front Door Side Weatherstrip. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Side Weatherstrip. Repair procedures

Replacement

1.
Loosen the front door checker (B) mounting bolt.
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft)
2.
Detach the clips, then remove the front door side weatherstrip (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Front Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the front door trim. 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

Rear Door
...

See also:

26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Repair procedures
On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs. • If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to ...

Hazard Lamp Switch. Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of hazard lamp switch ...