Hyundai Santa Fe: Rear Door
Ignition switch position Repair procedures Engine number
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the front door side weatherstrip ...
Front Door Side Weatherstrip. Repair procedures
Components 1. Rear door pull cap 2. Rear door trim 3. Rear door module 4. Rear door latch 5. Rear door panel 6. Rear door belt inside weatherstrip 7. Rear door belt outside weatherstrip 8. Rear door delta ...
Components and Components LocationSee also:
LOCK The steering wheel locks to protect against theft. The ignition key can be removed only in the LOCK position. When turning the ignition switch to the LOCK position, push the key inward at the ACC ...
Inspection [Evap Leak Test] Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV) and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are satisfied. ECM displays ...
The engine number is stamped on the engine block as shown in the drawing. ...
