Hyundai Santa Fe: Front Door Trim. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe: Front Door Trim. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Be careful not to scratch the door trim and other parts.
1.
Using a screwdriver or remover, remove the front door quadrant inner cover (A).
2.
Disconnect the tweeter speaker connector (A).
3.
Remove the front door pull cap (A).
4.
After loosening the mounting screws, then remove the front door trim (A).
5.
Remove the front door inside handle cage (A).
6.
Disconnect the outside rear view mirror switch connector (A), power window switch connector (B), front door lamp connector (C).
7.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

Front Door Trim. Components and Components Location
Component Location 1. Front door trim ...

Front Door Inside Handle. Repair procedures
Replacement 1. Remove the front door trim. 2. After loosening the mounting screws, then remove the front door inside handle (A). 3. Install in the reverse order of removal. • Make sure the door locks/unlocks ...

See also:

Direct Electro Hydraulic Actuator Coupling. Repair procedures
Inspection All units are filled up with coupling fluid (ultra-low viscosity ATF) prior to shipping. Inspection, fill-up, and replacement of coupling fluid is therefore not necessary (zero maintenance, ...

Canister Close Valve (CCV). Specifications
Specification Item Specification Coil Resistance (Ω) 19.9 ~ 22.9 [20°C(68°F) ...

Front Wheel Components and Components Location
Components Location 1.Under cover 2. Transaxle Assembly 3. Transfer assembly 4. Propeller shaft 5. Coupling assembly ...