Hyundai Santa Fe: Rheostat. Repair procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad side cover.
|
| 3. |
Remove the lower crash pad switch assembly (A) after
loosening the screws (3EA).
|
| 4. |
Remove the rheostat switch connector (A).
|
| 5. |
Check for intensity of new rheostat switch. If the
light intensity of the lamps changes smoothly without any flickering
when the rheostat is turned, it can be assumed that the rheostat is
normal.
|
Hazard Lamp Switch. Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of hazard lamp switch ...
Front Fog Lamps. Repair procedures
Inspection Front Fog Lamp Switch 1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunction ...
See also:
Air bag - supplemental restraint system
(1) Driver’s front air bag (2) Passenger’s front air bag (3) Side impact air bag (4) Curtain air bag (5) Driver’s knee air bag WARNING Even in vehicles with air bags, you and your passengers must ...
Troubleshooting
Troubleshooting Ignition System Symptom Suspect Area Remedy Engine will not start or is hard to start (Cranks OK) Ignition lock switch Inspect ignition lock switch, or replace as required Ignition coil ...
Components and Components Location
Components (1) 1. Main crash pad assembly 2. Crash pad side cover [LH] 3. Crash pad side cover [RH] 4. Steering column shroud lower panel 5. Crash pad lower panel 6. Fuse box cover 7. Crash pad under cover ...
