Hyundai Santa Fe: Front Oil Seal. Repair procedures
Removal and Installation
| 1. |
Remove the crankshaft damper pulley.
|
| 2. |
Remove the front oil seal(A).
|
| 3. |
Install the crankshaft front oil seal (A) using SST
(09214-3K000, 09231-H1100) (B).
|
Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...
Timing Chain Cover. Repair procedures
Removal • Use fender covers to avoid damaging painted surfaces. • To avoid damage, unplug the wiring connectors carefully while holding the connector portion. Mark all wiring and hoses to avoid misconnection. ...
See also:
Delivery Pipe. Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair ...
All Wheel Drive (AWD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select AWD Lock ...
General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airbags could accidentally ...
