Hyundai Santa Fe: External Amplifier. Repair procedures - AVN System - Body Electrical SystemHyundai Santa Fe: External Amplifier. Repair procedures

Removal

External Amplifier
1.
Remove the passenger seat assembly.
2.
Remove the external amplifier (A) after disconnecting the connectors and loosening the mounting bolts (3EA).


Installation

External Amplifier
1.
Install the external amplifier after connecting the connector.
2.
Install the passenger seat assembly.
-
Make sure the speaker and related connectors are plugged in properly.

External Amplifier. Components and Components Location
Components Connector Pin Information No. Connector A (26 pin) Connector B (16 pin) Connector C (12 pin) 1 Battery + Right surround speaker + Rear right door + 2 Battery + Left surround speaker + Rear left ...

See also:

Repair procedures
Inspection 1. Remove the cowl top cover. 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. 4. Turn the ignition ...

Rear Door Inside Handle. Repair procedures
Replacement 1. Remove the rear door trim. 2. After loosening the mounting screws, then remove the rear door inside handle (A). 3. Install in the reverse order of removal. • Make sure the door locks/unlocks ...

Illuminated engine start/stop button
Whenever the front door is opened, the engine start/stop button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. It will also go off immediately ...