Hyundai Santa Fe: Front Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Santa Fe: Front Wheel Speed Sensor. Repair procedures

Removal

1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the front wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 7.6 lb-ft)

3.
Remove the front wheel guard .
4.
Remove the front wheel speed sensor cable mounting bolt (A).
5.
Disconnect the front wheel speed sensor connector (B) and then remove the front wheel speed sensor.
6.
Installation is the reverse of removal.

Front Wheel Speed Sensor. Components and Components Location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

See also:

Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1Warning pattern repeats 11 times with an interval of 24 ...

Heated Schematic Diagrams
System Circuit Diagram Terminal Function Housing Pin Function Wire color Pad A GND Back B HEATER Yellow C NTC+ Back / Yellow D NTC- Back Remote control A GND Back B BAT Red C LED Green D SWITCH White ...

Console Armrest. Components and Components Location
Component Location 1. Console armrest ...