Hyundai Santa Fe: Fuel Filler Door Release Actuator. Repair procedures
Inspection
| 1. |
Remove the left luggage side trim.
|
| 2. |
Remove the subwoofer.
|
| 3. |
Remove the fuel filler housing after opening the
fuel filler door.
|
| 4. |
Loosen the fuel filler actuator mounting bolts (2EA).
|
| 5. |
Remove the fuel filler door release actuator (A)
after disconnecting the fuel filler door release actuator connector
(A).
|
| 6. |
Check for continuity between terminal No. 1 and No.
2. If there is no continuity, replace the fuel filler door release actuator
(A).
|
Components and Components Location
Component Location 1. Fuel filler door open switch 2. Fuel filler door release actuator ...
Fuel Filler Door Open Switch. Repair
procedures
Inspection 1. Remove the front door trim. 2. Disconnect the switch connector (A) from wiring. 3. Check the switch for continuity between the No. 1 and No. 2 terminals. If the continuity is not as specified, ...
See also:
Audio Remote Control. Repair procedures
Inspection 1. Check for resistance between terminals in each switch position. [Audio] Switch Connector terminal Resistance (± 5%) SEEK up 2-7 430 Ω SEEK down 2-7 1.11 kΩ Mode 2-7 2.11 kΩ ...
Specifications - Revised
Specifications Description Specifications Limit General Type In-line, DOHC Number of cylinders 4 Bore 88 mm (3.464 in) Stroke 97 mm (3.819 in) Total displacement 2359cc ...
Wheel. Repair procedures
Hub nut tightening sequence Tighten the hub nuts as follows. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) When using an impact gun, final tightening torque should be checked using ...
