Hyundai Santa Fe: Fuel Filler Door Open Switch. Repair
procedures
Inspection
| 1. |
Remove the front door trim.
|
| 2. |
Disconnect the switch connector (A) from wiring.
|
| 3. |
Check the switch for continuity between the No. 1
and No. 2 terminals. If the continuity is not as specified, replace
the switch.
|
Fuel Filler Door Release Actuator. Repair procedures
Inspection 1. Remove the left luggage side trim. 2. Remove the subwoofer. 3. Remove the fuel filler housing after opening the fuel filler door. 4. Loosen the fuel filler actuator mounting bolts (2EA). ...
Fuses And Relays
...
See also:
License plate lamp bulb replacement
1. Loosen the lens retaining screws with a screwdriver. 2. Remove the lens. 3. Remove the bulb. 4. Install a new bulb. 5. Reinstall the lens securely with the lens retaining screws. ...
Repair procedures
Replacement 1. Remove the cap (A) and remove the nuts, then remove the wiper arm (B). Tightening torque : 22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft) 2. Detach the clips, then remove the fender ...
Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle ...
