Hyundai Santa Fe: Fuel Pressure Control Valve. Repair procedures
Inspection
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the fuel pressure regulator valve connector.
|
| 3. |
Measure resistance between the fuel pressure regulator valve terminals
1 and 2.
|
| 4. |
Check that the resistance is within the specification.
|
Fuel Pressure Control Valve. Schematic Diagrams
Circuit Diagram ...
Canister Close Valve (CCV). Description and Operation
Description Canister Close Valve (CCV) is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosphere when leakage detecting system ...
See also:
Crankshaft Position Sensor (CKPS). Description and Operation
Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the If there is no CKPS signal input, the engine may stop because of CKPS signal ...
26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1, 1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...
Fuse/Relay panel description
Inside the fuse/relay box covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to your vehicle. ...
