Hyundai Santa Fe: High Mounted Stop Lamp. Repair procedures
Removal
| High Mounted Stop Lamp |
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear spoiler.
|
| 3. |
Remove the high mounted stop lamp assembly (A) after
loosening screws (4EA).
|
Installation
| 1. |
Install the high mounted stop lamp.
|
| 2. |
Install the rear spoiler.
|
| 3. |
Connect the negative (-) battery terminal.
|
License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...
Luggage Room Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver after loosening the screws (2EA). 3. Remove the luggage room lamp bulb (A). ...
See also:
Pressure Sensor. Schematic Diagrams
Circuit Diagram ...
Side Body. Body Repair
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. ...
Special Service Tools
Special Service Tools Tool(Number and Name) Illustration Use 09495-33000 Puller Removal of spider assembly from a drive shaft. 09568-4A000 Ball joint puller Remove the ball joint 09495-3K000 Band installer ...
