Hyundai Santa Fe: Power Door Mirror Actuator. Repair
procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Disconnect the connector (B) after removing the front
door quadrant cover (A).
|
| 3. |
Disconnect the power door mirror connector (A) from
the harness.
|
| 4. |
Apply battery voltage to each terminal as shown in
the table and verify that the mirror operates properly.
[Actuator]
Mirror Heater
Turn Signal Lamp
|
Power Door Mirror Switch. Repair
procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the front left door trim. 3. Remove the power mirror switch (A) from the door trim. Installation 1. Install the power mirror switch. 2. ...
Power Windows
...
See also:
Variable Intake Solenoid (VIS) Valve. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance between VIS valve terminals 1 and 2. Specification: Refer to "Specification" Removal 1. ...
Schematic Diagrams
Circuit Diagram ...
26 Brake Control Solenoid Valve(26/B_VFS). Specifications
Specifications Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81~500.14 (0.1~5.1, 1.42~72.54) Current value(mA) 50~850 Internal resistance(Ω) ...
