Hyundai Santa Fe (DM): Hood Insulator Pad. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe (DM): Hood Insulator Pad. Repair procedures

Replacement

1.
Using a clip remover, detach the clips, and remove the hood insulator pad (A).
•
Be careful not to scratch the hood panel.

2.
Install in the reverse order of removal.
•
Replace any damaged clips.

Hood Lift. Repair procedures
Replacement • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, lift the socket clips (A) up slightly on ...

Hood Seal Weatherstrip. Repair procedures
Replacement 1. Detach the clips, then remove the hood seal weatherstrip (A). • Be careful not to scratch the hood seal weatherstrip. 2. Install in the reverse order of removal. • Replace any damaged ...

See also:

26 Brake Control Solenoid Valve(26/B_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...

Variable Intake Solenoid (VIS) Valve. Specifications
Specification Item Specification Coil resistance (Ω) 30.0 ~ 35.0 [20°C(68°F)] ...

Canister Close Valve (CCV). Specifications
Specification Item Specification Coil Resistance (Ω) 19.9 ~ 22.9 [20°C(68°F) ...