Hyundai Santa Fe: Hood Lift. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe: Hood Lift. Repair procedures

Replacement

•
When removing and installing the hood lifter, an assistant is necessary.
•
When removing the clips, use a clip remover.
1.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the lifter (B).
2.
Push the socket of the lifter into the bracket for installation.
•
Make sure the hood locks/unlocks and opens/closes properly.

Hood Assembly. Repair procedures
Replacement • Be careful not to damage the hood and body. • When removing and installing the hood, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, ...

Hood Insulator Pad. Repair procedures
Replacement 1. Using a clip remover, detach the clips, and remove the hood insulator pad (A). • Be careful not to scratch the hood panel. 2. Install in the reverse order of removal. • Replace any damaged ...

See also:

Winter driving
Severe weather conditions in the winter result in greater wear and other problems. To minimize the problems of winter driving, you should follow these suggestions: ...

To fold down the rear center seatback
1. Lower the rear headrests to the lowest position. 2. Push the center seatback folding lever up, then fold the seat toward the front of the vehicle. When you return the seatback to its upright position, ...

Turn signals and lane change signals
The ignition switch must be on for the turn signals to function. To turn on the turn signals, move the lever up or down (A). Green arrow indicators on the instrument panel indicate which turn signal is ...