Hyundai Santa Fe: Hood Latch. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe: Hood Latch. Repair procedures

Replacement

[Hood upper latch assembly]
1.
After loosening the mounting bolts, then remove the hood upper latch assembly (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Install in the reverse order of removal.
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
[Hood lower latch assembly]
1.
Remove the front bumper cover.
2.
Remove the hood lower latch assembly (A) mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Disconnect the hood lower latch connector (A).
4.
Disconnect the hood latch release handle cable (B) and remove the hood lower latch assembly (A).

5.
Install in the reverse order of removal.
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.

Hood Latch. Components and Components Location
Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

Tail Gate
...

See also:

ETC (Electronic Throttle Control) System. Repair procedures
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification: Refer ...

Knee Airbag (KAB) Module. Description and Operation
Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. Never attempt ...

Seat belt - Driver's 3-point system with emergency locking retractor
To fasten your seat belt: To fasten your seat belt, pull it out of the retractor and insert the metal tab (1) into the buckle (2). There will be an audible "click" when the tab locks into the ...