Hyundai Santa Fe: If engine turns over normally but does not start - If the engine does not start - What to do in an emergencyHyundai Santa Fe: If engine turns over normally but does not start

1. Check fuel level.

2. With the ignition switch in the LOCK position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose.

3. If the engine still does not start, call an authorized HYUNDAI dealer or seek other qualified assistance.

If engine doesn't turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...

See also:

Inhibitor Switch. Repair procedures
Inspection • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Power Circuit Inspection 1. Disconnect the Inhibitor swtich connector. ...

Schematic Diagrams
Circuit Diagram ...

Front Driveshaft. Components and Components Location
Components 1. Front driveshaft (LH) 2. Inner shaft bearing bracket 3. Front driveshaft (RH) [LH] 1. BJ assembly 2. Clip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ ...