Hyundai Santa Fe: If you do decide to pull a trailer - Trailer towing - Driving your vehicleHyundai Santa Fe: If you do decide to pull a trailer

Here are some important points if you decide to pull a trailer:

  • Consider using a sway control.You can ask a hitch dealer about sway control.
  • Do not do any towing with your car during its first 1,200 miles (2,000 km) in order to allow the engine to properly break in. Failure to heed this caution may result in serious engine or transaxle damage.
  • When towing a trailer, be sure to consult an authorized HYUNDAI dealer for further information on additional requirements such as a towing kit, etc.
  • Always drive your vehicle at a moderate speed (less than 60 mph (100 km/h)).
  • On a long uphill grade, do not exceed 45 mph (70 km/h) or the posted towing speed limit, whichever is lower.
  • The chart contains important considerations that have to do with weight:

Weight of the trailer

Maintenance when trailer towing
Your vehicle will need service more often when you regularly pull a trailer. Important items to pay particular attention to include engine oil, automatic transaxle fluid, axle lubricant and cooling system ...

Weight of the trailer
What is the maximum safe weight of a trailer? It should never weigh more than the maximum trailer weight with trailer brakes. But even that can be too heavy. It depends on how you plan to use your trailer. ...

See also:

Coolant. Repair procedures
Refilling And Bleeding Never remove the radiator cap when the engine is hot. Serious scalding could be caused by hot fluid under high pressure escaping from the radiator. When pouring engine coolant, be ...

Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...

Rear Wheel Speed Sensor. Components and Components Location
Components 1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...