Hyundai Santa Fe: Instrument Cluster Control - Instrument cluster - Features of your vehicleHyundai Santa Fe: Instrument Cluster Control

Adjusting Instrument Cluster Illumination

The brightness of the instrument panel illumination is changed by moving the

The brightness of the instrument panel illumination is changed by moving the illumination control knob right or left when the ignition switch or Engine Start/Stop button is ON, or the tale lights are turned on.

Информация двухроторный вакуумный насос здесь.

  • The brightness has 20 levels : 1 (MIN) ~ 20 (MAX)
  • If you hold the illumination control knob on the right end (+) or left end (-), the brightness will be changed continuously.
  • If the brightness reaches to the maximum or minimum level, an alarm will sound.
Instrument cluster
Type A Type B 1. Tachometer 2. Speedometer 3. Engine coolant temperature gauge 4. Fuel gauge 5. LCD display 6.Warning and indicator lights (if equipped) 7. Turn signal indicator lights ❈ The actual ...

LCD Display Control
The LCD display modes can be changed by using the control buttons on the steering wheel. (1) : MODE button for changing modes (2) : MOVE button for changing items (3) : SELECT/RESET button for setting ...

See also:

Engine Control Module (ECM). Schematic Diagrams
ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-A] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output [NON-smart key type] Ignition Coil (Cylinder ...

Vehicle certification label
The vehicle certification label attached on the driver’s side center pillar gives the vehicle identification number (VIN). ...

SS-B Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...