Hyundai Santa Fe: Jump starting - Emergency starting - What to do in an emergencyHyundai Santa Fe: Jump starting

Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle or battery, follow the jump starting procedures. If in doubt, we strongly recommend that you have a technician or towing service jump start your vehicle.

CAUTION

Use only a 12-volt jumper system. You can damage a 12-volt starting motor, ignition system, and other electrical parts beyond repair by use of a 24-volt power supply (either two 12-volt batteries in series or a 24-volt motor generator set).

WARNING - Battery

  • Keep all flames or sparks away from the battery. The battery produces hydrogen gas which may explode if exposed to flame or sparks. If these instructions are not followed exactly, serious personal injury and damage to the vehicle may occur! If you are not sure how to follow this procedure, seek qualified assistance. Automobile batteries contain sulfuric acid. This is poisonous and highly corrosive. When jump starting, wear protective glasses and be careful not to get acid on yourself, your clothing or on the car.
  • Do not attempt to jump start the vehicle if the discharged battery is frozen or if the electrolyte level is low; the battery may rupture or explode.
Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...

Jump starting procedure
✽ NOTICE If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal ...

See also:

Front Washer Motor. Repair procedures
Inspection Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign ...

Telemetics Unit (TMU). Components and Components Location
Component Connector Pin Information [Audio type] No. Description No. Description 1 Ground 17 - 2 Ground 18 Battery 1 3 - 19 IGN 1 4 Keypad ground 20 ACC 5 MIC output - 21 Airbag 6 MIC output + 22 Keypad ...

Input Speed Sensor. Description and Operation
Description Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor ...