Hyundai Santa Fe: Oil Pressure Switch. Repair procedures
Inspection
| 1. |
Check the continuity between the terminal and the
body with an ohmmeter.
If there is no continuity, replace the oil pressure
switch.
|
| 2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 50kPa (0.50kgf/cm²,
7.25psi) is applied through the oil hole, the switch is operaing properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
Balance Shaft & Oil Pump. Repair procedures
Removal 1. Remove the timing chain. 2. Install a stopper pin (A) after compressing the balance shaft chain tensioner. 3. Remove the balance shaft chain hydraulic tensioner (B). 4. Remove the balance shaft ...
Oil Level Gauge & Pipe. Repair procedures
Removal and Installation 1. Remove the oil gauge(A). 2. Remove the intake manofold. 3. Remove the oil level pipe(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft) 4. Install in ...
See also:
Hands Free Mic. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Seperate the handsfree mic (A) from the roof trim. 3. Remove the handsfree mic (B) after disconnecting the handsfree mic connector (A). 4. ...
Maintenance services
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the inspection ...
Injector. Troubleshooting
Signal Waveform ...
