Hyundai Santa Fe: Map lamp
Type A
Type B
Press the lens (1) to turn the map lamp on or off
- ON (2): The map lamp and room lamp stays on at all times.
- OFF (3): The lamps are off even if a door is opened.
- ROOM (4): The map lamp and room lamp stays on at all times.
- DOOR (5):
- The map lamp and room lamp comes on when a door is opened. The lamps go out after approximately 30 seconds.
- The map lamp and room lamp comes on for approximately 30 seconds when doors are unlocked with a transmitter or smart key as long as the doors are not opened.
- The map lamp and room lamp will stay on for approximately 20 minutes if a door is opened with the ignition switch in the ACC or LOCK/OFF position.
- The map lamp and room lamp will stay on continuously if the door is opened with the ignition switch in the ON position.
- The map lamp and room lamp will go out immediately if the ignition switch is changed to the ON position or all doors are locked.
✽ NOTICE
When the lamp is turned on by pressing the lens (1), the lamp does not turn off even if the switch is in the OFF position (3).
Automatic turn off function
The interior lights automatically turn off approximately 20 minutes after the ignition switch is turned off. If your vehicle is equipped with the theft alarm system, the interior lights automatically turn ...
Room lamp
Type A Type B Press the button to turn the light on or off. CAUTION Do not leave the lamp switches on for an extended period of time when the vehicle is not running because the battery may drain. ...
See also:
Warning Messages
Shift to "P" position (for smart key system and automatic transaxle) This warning message illuminates if you try to turn off the engine without the shift lever in P (Park) position. At this time, ...
Repair procedures
General Inspection After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal ...
Charging System Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with either the ...
