Hyundai Santa Fe: Panorama Sunroof Switch. Repair
procedures
Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Open the sunglass case cover from the overhead console
then remove the 2 screws holding the overhead console. Disconnect the
switch connector and Map lamp connector, and then remove the overhead
console lamp (A).
|
| 3. |
Check for continuity between the terminals. If the
continuity is not as specified, replace the panoramaroof switch.
|
Panorama Sunroof Switch. Components
and Components Location
Components ...
Panorama Sunroof Motor. Repair
procedures
Inspection 1. Close the panorama sunroof glass and blind completely (Full close position). 2. Disconnect the negative (-) battery terminal. 3. Remove the roof trim assembly. 4. Remove the panorama sunroof ...
See also:
Knee Airbag (KAB) Module. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the crash pad lower panel. 3. After loosening the mounting nuts and then remove the ...
Accelerator Position Sensor (APS). Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors in engine ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform ...
