Hyundai Santa Fe: Power Door Mirror Switch. Repair
procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front left door trim.
|
| 3. |
Remove the power mirror switch (A) from the door
trim.
|
Installation
| 1. |
Install the power mirror switch.
|
| 2. |
Install the front door trim after connecting the
connector.
|
| 3. |
Connect the negative (-) battery terminal.
|
Inspection
| 1. |
Remove the front left door trim.
|
| 2. |
Remove the power mirror switch (A) from the door
trim.
|
| 3. |
Check for continuity between the terminals in each
switch position according to the table.
[Power Mirror Switch]
|
Power Door Mirror Switch. Schematic
Diagrams
Circuit Diagram ...
Power Door Mirror Actuator. Repair
procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Disconnect the connector (B) after removing the front door quadrant cover (A). 3. Disconnect the power door mirror connector (A) from the ...
See also:
Pressure Sensor. Description and Operation
Description The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an oil pressure. And then it presses a multiple disk clutch and transfers the generated torque into rear wheels. Its torque ...
Timing Chain. Repair procedures
Removal 1. Remove the cylinder head cover. 2. Turn the crankshaft pulley and align its groove with the timing mark of the timing chain cover to set the piston of No.1 cylinder to the top dead center on ...
Front Mud Guard. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
