Hyundai Santa Fe: Rear Axle Assembly
Troubleshooting Fuel Pressure Control Valve. Repair procedures In the event of brake failure
Removal 1. Remove the front driveshaft. 2. Remove the TJ joint assembly. 3. Remove the Dynamic damper. 4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A). 5. Remove the BJ boot. ...
BJ Boot. Repair procedures
Components 1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...
Rear Hub - Carrier. Components and Components LocationSee also:
Troubleshooting Symptom Possible cause Remedy One lamp does not light (all exterior) Bulb burned out Replace bulb Socket, wiring or ground faulty Repair if necessary Head lamps do not light Bulb burned ...
Inspection 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the fuel pressure regulator valve connector. 3. Measure resistance between the fuel pressure regulator ...
If service brakes fail to operate while the vehicle is in motion, you can make an emergency stop with the parking brake. The stopping distance, however, will be much greater than normal. WARNING - Parking ...
