Hyundai Santa Fe: Reservoir Tank. Repair procedures
Removal and Installation
| 1. |
Remove the over flow hose(A).
|
| 2. |
Remove the reservoir tank(B).
|
| 3. |
Install in the reverse order of removal.
|
Cooling Fan. Repair procedures
Removal and Installation Cooling Fan Assembly 1. Disconnect the battery terminals. 2. Remove the air cleaner assembly. 3. Remove the under cover. 4. Remove the front bumper cover. 5. Disconnect ...
Water Temperature Control Assembly. Components and Components
Location
Components 1. O-ring 2. Water temperature control assembly 3. Water inlet fitting 4. Engine coolant temperature sensor 5. Thermostat 6. Thermostat gasket 7. Oil cooler coolant hose ...
See also:
Checking the engine oil level
Type A Type B 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for ...
Components and Components Location
Component Location 1. Overdrive Clutch (OD/C) 2. One way Clutch (OWC) 3. Low & Reverse Brake (LR/B) 4. Underdrive Brake (UD/B) 5. 26 Brake(26/B) 6. 35R Clutch (35R/C) 7. Damper Clutch (D/C) ...
TJ Joint. Components and Components Location
Components [LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. TJ housing 11. Housing circlip [RH] 1. BJ assembly 2. ...
