Hyundai Santa Fe: BJ Boot. Repair procedures - Driveshaft Assembly - Driveshaft and axleHyundai Santa Fe: BJ Boot. Repair procedures

Removal

1.
Remove the front driveshaft.
2.
Remove the TJ joint assembly.
3.
Remove the Dynamic damper.
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
7.
Check the front alignment.

BJ Boot. Components and Components Location
Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing 13. ...

Rear Axle Assembly
...

See also:

Antenna. Repair procedures
Inspection Antenna Cable 1. Remove the antenna jack from the audio unit and antenna. 2. Check for continuity between the center poles of antenna cable. 3. Check for continuity between the outer poles of ...

Start/Stop Button. Components and Components Location
Component ...

Front Wheel Speed Sensor. Components and Components Location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...