Hyundai Santa Fe: Rear Bumper Cover. Repair procedures - Rear Bumper - Body (Interior and Exterior)Hyundai Santa Fe: Rear Bumper Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
After loosening the mounting screws, then remove the rear combination lamp (A).
2.
Disconnect the rear combination lamp connector (A).
3.
Loosen the rear bumper lower mounting clips.
4.
Loosen the mounting bolts.
5.
Disconnect the rear bumper main connector (A).
6.
After loosening the rear bumper side's mounting screws, then disconnect the side's.
7.
Loosen the rear bumper upper mounting clip.
8.
Remove the rear bumper cover (A).
9.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Rear Bumper Cover. Components and Components Location
Component Location 1. Rear bumper cover ...

Rear Bumper beam Assembly. Components and Components Location
Component Location 1. Rear bumper beam assembly ...

See also:

Pre-tensioner seat belt
Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts (retractor pretensioner and EFD (Emergency Fastening Device)). The pre-tensioner seat belts can be activated, ...

Air bag warning label
Air bag warning labels, some required by the U.S. National Highway Traffic Safety Administration (NHTSA), are attached to alert the driver and passengers of potential risks of the air bag system. ...

CVVT Oil Control Valve (OCV). Specifications
Specification Item Specification Coil Resistance (Ω) 6.9 ~ 7.9 [20°C(68°F)] ...