Hyundai Santa Fe: Rear Lower Arm. Repair procedures
Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
Support the rear lower arm (A) with a jack as shown in the illustration.
|
| 3. |
Loosen the bolt & nut and then remove the rear lower arm (A) with
the rear axle.
|
| 4. |
Loosen the bolt & nut and then remove the rear lower arm (B) with
the sub frame (A).
|
| 5. |
Installation is the reverse of removal.
|
| 6. |
Check the rear alignment.
|
Inspection
| 1. |
Check the bushing for wear and deterioration.
|
| 2. |
Check the rear lower arm for deformation.
|
Rear Upper Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
See also:
To turn off the blowers
To turn off the blowers, turn the fan speed control knob to the “0” position. ...
Hazard warning flasher
Type A Type B The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far ...
Input Speed Sensor. Description and Operation
Description Input speed sensor (A) is a vital unit that measures the rate of rotation of the input shaft inside the transaxle and delivers the readings to the Transaxle Control Module(TCM). The sensor ...
