Hyundai Santa Fe: Rear Coil Spring. Repair procedures - Rear Suspension System - Suspension SystemHyundai Santa Fe: Rear Coil Spring. Repair procedures

Removal

1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque :
88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Support the rear lower arm (A) with a jack as shown in the illustration.
Certainly install Jack as being danger because of the tension.

3.
Remove the spring (A), the upper pad (B) and the lower pad (C).
Tightening torque :
137.3 ~ 156.9N.m (14.0 ~ 16.0kgf.m, 101.3 ~ 115.7lb-ft)

4.
Installation is the reverse of removal.
5.
Check the rear alignment.

Inspection

1.
Check the spring for distortion, aging or damage.
2.
Check the spring upper pad and lower pad for aging or damage.

Rear Lower Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

Trailing Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...

See also:

SRS Control Module (SRSCM). Components and Components Location
Components ...

Steering Gear box. Repair procedures
Removal 1. Remove the front wheel and tire (A) from front hub. Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) • Be careful not to damage to the hub bolts when removing the ...

All Wheel Drive (AWD) LOCK Indicator Light
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select AWD Lock ...