Hyundai Santa Fe: Rear Washer Motor. Repair procedures - Rear Wiper/Washer - Body Electrical SystemHyundai Santa Fe: Rear Washer Motor. Repair procedures

Inspection

1.
With the washer motor connected to the reservoir tank, fill the reservoir tank with water.
Before filling the reservoir tank with water, check the filter for foreign material or contamination. if necessary, clean the filter.
2.
Remove the front bumper cover.
3.
Connect positive (+) and negative (-) battery cables to terminals 3 and 2 respectively to see that the washer motor runs and water is pumped.
4.
Check that the motor operates normally.
Replace the motor if it operates abnormally.
No.
 Description
1
 Ground
2
 Windshield washer (+)
3
 Rear washer (+)


Rear Washer Switch. Repair procedures
Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Washer Switch ...

Electro Chromic Inside Rear View Mirror
...

See also:

Instrument Cluster. Components and Components Location
Components Connector Pin Information No. Description No. Description 1 - 21 - 2 Illumination output 22 - 3 Rheostat down switch 23 4P output 4 Rheostat up switch 24 Immobilizer 5 AT N output 25 AT S output ...

Air intake control
This is used to select the outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position Type A, B The indicator ...

4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...