Hyundai Santa Fe: Rear Washer Switch. Repair procedures - Rear Wiper/Washer - Body Electrical SystemHyundai Santa Fe: Rear Washer Switch. Repair procedures

Inspection

1.
Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Rear Wiper Switch

Rear Washer Switch


Rear Wiper Motor. Repair procedures
Inspection Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively. 3. Check that the motor operates ...

Rear Washer Motor. Repair procedures
Inspection 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign material or contamination. ...

See also:

4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct size may ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. WARNING Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position, ...