Hyundai Santa Fe: Removal and installation
To remove the headrest :
1. Raise it as far as it can go then press the release button (1) while pulling the headrest up (2).
To reinstall the headrest :
1. Put the headrest poles (3) into the holes while pressing the release button
(1).
2. Adjust it to the appropriate height.
WARNING
- Make sure the headrest locks in position after adjusting it to properly protect the occupants.
- After installing the headrest, make sure that it is installed in the right direction. A headrest installed reversely could increase whiplash injury during rear impact.
Adjusting the height up and down
To raise the headrest : 1. Pull it up to the desired position (1). To lower the headrest : 1. Push and hold the release button (2) on the headrest support 2. Lower the headrest to the desired position ...
Armrest
To use the armrest, pull it forward from the seatback. ...
See also:
Components and Components Location
Components 1. Front seat belt pretensioner / EFD system 2. Height adjuster 3. Second row seat belt 4. Third row seat belt ...
Tire traction
Tire traction can be reduced if you drive on worn tires, tires that are improperly inflated or on slippery road surfaces. Tires should be replaced when tread wear indicators appear. To reduce the possibility ...
Mode selection
The mode selection button controls the direction of the air flow through the ventilation system. The air flow outlet port is converted as follows: Refer to the illustration in the “Manual climate control ...
