Hyundai Santa Fe: Repair procedures - Crankcase Emission Control System - Emission Control SystemHyundai Santa Fe: Repair procedures

Inspection

1.
After disconnecting the vapor hose from the PCV valve, remove the PCV valve.
2.
Reconnect the PCV valve to the vapor hose.
3.
Inspect the PCV vlave operation.
(1)
Run the engine at idle.
(2)
Put a finger on the open end of the PCV valve.
(3)
Make sure that intake manifold vaccum can be felt.
The plunger inside the PCV valve will move back and forth at vacuum.

4.
If the vacuum is not felt, clean or replace the vapor hose.

Schematic Diagrams
Schematic Diagram ...

Positive Crankcase Ventilation (PCV) Valve. Description and Operation
Operation Principle ...

See also:

Rear Transverse Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Brake Booster. Repair procedures
Brake Booster Operating Test For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses fully ...

Cup holder
Front Rear Cups or small beverage cans may be placed in the cup holders. To use the center cup holder, pull down the armrest and press the open button. WARNING - Hot liquids Do not place uncovered cups ...