Hyundai Santa Fe: Repair procedures
Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| • |
TCM replacement
|
| • |
TCM upgrading
|
TCM learning procedure
| 1. |
Automatic Transaxle Fluid (ATF) temperature: 40 ~ 100°C (104 ~
212°F)
|
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping
on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd,
3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified Throttle Position Sensor (TPS) value (15~25%).
|
Description and Operation
Description Automatic transaxle system relies on various measurement data to determine the current control status and extrapolate the necessary compensation values. These values are used to control the ...
See also:
Tire. Repair procedures
• Using tires and wheel other than the recommended sizes could cause unusual handling characteristics and poor vehicle control, resulting in a serious accident. Tire Wear 1. Measure the tread depth ...
Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid should be checked on a regular basis, with the exact interval depending on the fluid. Further details are provided in Section ...
ICM (Integrated Circuit Module)
Relay Box. Description and Operation
Description The ICM relay is united with (rear blower motor, cornering lamp, rear fog lamp, two turn unlock, burglar alram relay) which installed inside the lower crash pad. ...
