Hyundai Santa Fe: Repair procedures - Steering wheel - Steering SystemHyundai Santa Fe: Repair procedures

Removal

1.
Disconnect the battery negative cable from the battery and then wait for at least 30 seconds.
2.
Turn the steering wheel so that the front wheels can face straight ahead.
3.
Remove the airbag module.
4.
Disconnect the connector & lock nut (A) and then remove the steering wheel by using special service tools (09561-11001).
Tightening torque : 44.1 ~ 49.0N.m (4.5 ~ 5.0 kgf.m, 32.5 ~ 36.2lb-ft)
•
Do not hammer on the steering wheel to remove it; it may damage the steering column.

5.
Installation is the reverse of the removal.

Disassembly

1.
Loosen the screw and then remove the lower cover (A) from the steering wheel body.
2.
Disconnect the steering wheel remote switch connector (A).
3.
Remove the steering wheel remote switch (A) and (B).
4.
Installation is the reverse of the removal.

Components and Components Location
Components 1. Airbag module 2. Bezel 3. Remote control assembly 4. Steering wheel 5. Wiring 6. Lower cover ...

Heated Description and Operation
Description Heated pads to grip the steering grip makes the fever. 1. Heated control unit 2. Heated pad Specifications Item Specification Voltage 13.5 V Heated pad resistance 1.4 ~ 1.8 Ω  ± ...

See also:

Components and Components Location
Component Location 1. Windshield deicer relay (Built-in engine room relay box) 2. Windshield deicer switch (Dual type) 3. Windshield deicer switch (Manual type) 4. Windshield deiecr 5. Deicer connector ...

Injector. Troubleshooting
Signal Waveform ...

Relay Box (Passenger Compartment). Description and Operation
Description Smart Junction Box(SJB) 1. General function : Interior Junction Box + some functions of BCM It controls loads with CAN communication and IPS. 2. Main function A. Low speed CAN communication(100 ...