Hyundai Santa Fe: Repair procedures - Fender - Body (Interior and Exterior)Hyundai Santa Fe: Repair procedures

Replacement

•
Be careful not to damage the fender and body.
•
When removing the clips, use a clip remover.
1.
Remove the head lamps.
2.
Remove the side sill molding.
3.
Loosen the front wheel guard mounting clips and screws.
4.
Remove the fender side repeater lamp (A).
5.
Disconnect the fender side repeater lamp connector (B).
6.
Using a screwdriver or remover, remove the delta garnish (A).
7.
After loosening the mounting clips, then remove the fender side cover (A).
8.
After loosening the mounting screws, bolts, nut, then remove the fender assembly (A).
9.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Components and Components Location
Component Location 1. Fender assembly ...

Hood
...

See also:

Cooling Fan. Specifications
Specification Fuction Specification Maximum Drive Capability 250 W 21.0 + 10% A Input Signal Frequency 300 ± 5% Duty 10, 30 ~ 90 % Voltage level HI 0.7 V above LOW 0 ~ 1.9 V ...

Air bag non-inflation conditions
• In certain low-speed collisions the air bags may not deploy. The air bags are designed not to deploy in such cases because they may not provide benefits beyond the protection of the seat belts in ...

Repair procedures
On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) • Check that the battery cables ...