Hyundai Santa Fe: Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body Electrical System / Keyless Entry And Burglar Alarm / Repair procedures

Inspection

Front Door Lock Module Inspection

1.	Remove the front door trim.

2.	Remove the front door module.

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

5.	Check for continuity between the terminals in each switch position according to the table.

Rear Door Lock Module Inspection

1.	Remove the rear door trim.

2.	Remove the rear door module.

3.	Disconnect the connectors from the actuator.

4.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

5.	Check for continuity between the terminals in each switch position according to the table.

Tailgate Lock Module Inspection

1.	Remove the tailgate trim.

2.	Disconnect the 4P connector from the actuator.

3.	Check actuator operation by connecting power and ground according to the table. To prevent damage to the actuator, apply battery voltage only momentarily.

Tailgate Open Switch

1.	Remove the tailgate trim.

2.	Disconnect the 4P connector from the actuator.

3.	Check for continuity between the terminals in each switch position according to the table.

Hood Switch

1.	Disconnect the connector (A) and bolts from the hood switch.

2.	Check for continuity between the terminals and ground according to the table.

Burglar Horn

1.	Remove the burglar horn after removing a bolt and disconnect the 2P connector from the burglar horn.

2.	Test the burglar horn by connecting battery power to the terminal 1 and ground the terminal 2.

3.	The burglar horn should sound. If the burglar horn fails to sound replace it.

Description and Operation

Description Burglar Alarm State [B/A State] B/A State Description DISARM 1. In "DISARM" state, no vehicle start inhibition. So, when door, hood, or Tailgate is opened, there is no alarm sound ...

Transmitter. Repair procedures

Inspection 1. Check that the red light flickers when the door lock or unlock button is pressed on the transmitter. 2. Remove the battery (A) and check voltage if the red light doesn't flicker. Standard ...