Hyundai Santa Fe: Immobilizer Control Unit. Repair
procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the driver crash pad lower panel.
|
| 3. |
Remove the knee airbag module.
|
| 4. |
Disconnect the connector of the immobilizer unit
and then remove the immobilizer bolt (A) after loosening a nut.
https://modulnye-poly.ru/pokrytiya-iz-pvh/ модульная плитка пвх для улицы.
|
Installation
| 1. |
Install the immobilizer control unit after connecting
the unit connector.
|
| 2. |
Install the crash pad lower panel and knee airbag
module.
|
| 3. |
Connect the negative (-) battery terminal.
|
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a PCM(ECM) ...
Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening ...
See also:
Maintenance when trailer towing
Your vehicle will need service more often when you regularly pull a trailer. Important items to pay particular attention to include engine oil, automatic transaxle fluid, axle lubricant and cooling system ...
Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds. 2. Release ...
Schematic Diagrams
Circuit Diagram Connector Pin Information No. Wire harness connector Panorama motor Blind motor 1 Ground 1 Ground 1 Ground 2 2 Glass status signal / Tool fot glass Glass status signal/ Tool (Parameter) ...
