Hyundai Santa Fe: Repair procedures
Inspection
| 1. |
Turn the ignition key to the "ON" position.
|
| 2. |
Cover the forward facing sensor.
|
| 3. |
Head a light to the rearward looking sensor.
|
| 4. |
The ECM should be darkened as soon as the rearward
looking sensor detects the light.
|
| 5. |
When the reverse gear is engaged, the ECM should
not be darkened.
When heading lights to both the forward facing and
rearward looking sensors, the ECM should not be darkened.
|
Removal
| 1. |
Remove the mirror wiring cover (A).
|
| 2. |
Remove the mirror mounting screw (A) and connector
(B).
|
| 3. |
Remove the mirror (A) pulling up in the arrow direction.
|
Installation
| 1. |
Install the mirror making sure the mounting bracket
not to be damaged.
|
| 2. |
Install the mirror wiring cover after reconnecting
the connector and tightening the screw.
|
Description
and Operation
Description The ECM (Electro Chromatic inside rear view Mirror) is intended dim the reflecting light in the rear view mirror. The forward facing sensor detects brightness of the surroundings, while the ...
See also:
Checking the engine oil level
Type A Type B 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for ...
Do not use methanol
Fuels containing methanol (wood alcohol) should not be used in your vehicle. This type of fuel can reduce vehicle performance and damage components of the fuel system. ✽ NOTICE Your New Vehicle ...
Electronic stability control (ESC)
The Electronic Stability Control (ESC) system is designed to stabilize the vehicle during cornering maneuvers. ESC checks where you are steering and where the vehicle is actually going. ESC applies the ...




