Hyundai Santa Fe: Side Airbag (SAB) Module. Repair procedures - Airbag Module - RestraintHyundai Santa Fe: Side Airbag (SAB) Module. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the front seat assembly.
3.
Remove the seat back assembly.
The side airbag cannot be disassembled from the seat back assembly, so replace the seat back assembly when replacing the side airbag.

Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
•
Do not open the lid of the side airbag cover.
•
Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Install the new seat back assembly.
4.
Install the front seat assembly.
5.
Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfere with other parts.
6.
Reconnect the battery negative cable.
7.
After installing the side airbag (SAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Side Airbag (SAB) Module. Components and Components Location
Components ...

Curtain Airbag (CAB) Module. Description and Operation
Description Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by ...

See also:

Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad center panel. 3. Disconnect the body control module connectors (A). 4. Remove the body control module (A) after loosening ...

Transaxle Oil Temperature Sensor. Specifications
Specifications ▷ Type: Negative Thermal Coefficient Type(NTC) Temp.(°C)°F Resistance (kΩ) (-40)-40 48.1 (-20)-4.0 15.6 (0)32.0 5.88 (20)68.0 2.51 (40)104.0 1.11 (60)140.0 0.61 (80)176.0 0.32 ...

Repair procedures
Removal 1. Remove the front bumper cover. 2. Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B). [Disk type] [Shell type] Installation 1. Install ...