Hyundai Santa Fe: Resetting the sunroof - Panoramic sunroof - Features of your vehicleHyundai Santa Fe: Resetting the sunroof

Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows:

1.Turn the ignition switch to the ON position.
2.Close the sunshade and sunroof completely if opened.
3.Release the sunroof control lever.
4.Push the sunroof control lever forward in the direction of close (about 10 seconds) until the sunroof moves a little. Then, release the lever.
5.Push the sunroof control lever forward in the direction of close, until the sunroof operates as follows again:

The sunshade and sunroof glass
slide open → The sunroof glass
slide close → The sunshade close

Then, release the lever.

When this is complete, the sunroof system has been reset.

✽ NOTICE

If you do not reset the sunroof, it may not work properly.

Closing the sunroof
To close the sunroof glass and sunshade Push the sunroof control lever forward or pull the sunroof control lever down. The sunroof glass and sunshade will close automatically. To stop the sunroof movement ...

See also:

To turn off the blowers
To turn off the blowers, turn the fan speed control knob to the “0” position. ...

Rear Transverse Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...