Hyundai Santa Fe: Seat Belt Buckle Switch (BS). Repair procedures - SRSCM - RestraintHyundai Santa Fe: Seat Belt Buckle Switch (BS). Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS). Repair procedures

Removal

1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front seat assembly.
3.
Loosen the seat belt buckle mounting bolt and remove the seat belt buckle switch (A).

Installation

Be sure to install the harness wires so they will not pinch or interfere with other parts.
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
3.
Install the seat belt buckle switch.
Tightening torque:
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~39.8 lb-ft)
4.
Install the front seat assembly.
5.
Reconnect the battery negative cable.
6.
After installing the seat belt buckle switch, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

Seat Belt Buckle Switch (BS). Components and Components Location
Components ...

Passive Occupant Detection System (PODS-F). Description and Operation
Description In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passive occupant detection system (PODS-F). If the seat is occupied, PODS-F detects passenger presences status ...

See also:

Yaw-rate and G Sensor. Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...

Cowl Side Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Oil hydraulic Motor(Actuator). Description and Operation
Description The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil pressure. The pressure engages a multiple disk clutch to transfer torque to the rear wheels. The torque to the rear ...