Hyundai Santa Fe: Shift Lever. Components and Components Location
Components
|
1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly |
4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer |
Inhibitor Switch. Repair procedures
Inspection • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Power Circuit Inspection 1. Disconnect the Inhibitor swtich connector. ...
Shift Lever. Repair procedures
Removal 1. Remove the floor console. 2. Remove the air duct. 3. Disconnect sports mode connector (A). 4. Disconnect the shift cable (A). 5. Remove the shift lever assembly (A) by removing the bolts (C-4ea). ...
See also:
Knock Sensor (KS). Description and Operation
Description Knocking is a phenomenon characterized by undesirable vibration and noise and can cause engine damage. Knock Sensor (KS) is installed on the cylinder block and senses engine knocking. When ...
Yaw-rate and G Sensor. Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...
External Amplifier. Repair procedures
Removal External Amplifier 1. Remove the passenger seat assembly. 2. Remove the external amplifier (A) after disconnecting the connectors and loosening the mounting bolts (3EA). Installation External Amplifier ...
