Hyundai Santa Fe (TM): Special service tools - Engine Mechanical SystemHyundai Santa Fe (TM): Special service tools

Special Service Tools
Tool (Number and name)
Crankshaft front oil seal installer
(09214 - L1100)

Installation of the front oil seal.
A : 09214 - L1100
B : 09231-H1100
Ring gear stopper

Removal and installation of crankshaft pulley bolt.
Torque angle adapter

Installation of bolts & nuts needing an angular method of adjustment.
Valve stem oil seal installer

Installation of the valve stem oil seal.
Valve spring compressor & holder

Removal and installation of the intake or exhaust valve.
09222-3K100 (holder)
Crankshaft rear oil seal installer
(09214 - L1200)

Installation of the crankshaft rear oil seal.
A : 09214 - L1200
B : 09231-H1100
Oil pan remover

Removal of oil pan.
Water Pump Belt Remover & Installer

Used for removing / installing water pump belt.

Specifications Description Specifications Limit General Type In-line, DOHC   Number of cylinders 4   Bore 88.5 mm (3.484 in.)   Stroke 101.5 mm (3.996 in.)   Total displacement 2497 cc (152.38 ...

Repair procedures
Compression Pressure Inspection    • If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the ...

See also:

Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra distance for braking. Avoid sudden ...

Lift and Support Points
Lift and Support Points [Two-Post Car Lift] 1. Place the lift blocks under the support points as shown in the illustration. 2. Raise the hoist a little and visually check that the lift block is properly ...

Power Door Lock Switch. Repair procedures
Diagnosis With GDS 1. The BCM can be diagnosed by using the GDS. The BCM communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of power ...