Hyundai Santa Fe (TM): Specifications - 4 Wheel Drive (4WD) SystemHyundai Santa Fe (TM): Specifications

Specifications
Tightening Torques
Items
N.m
Kgf.m
lb-ft
Transfer assembly mounting bolts
60.8 - 65.7
6.2 - 6.7
44.8 - 48.5
4WD ECM mounting nuts
9.8 - 11.8
1.0 - 1.2
7.2 - 8.7
Coupling assembly mounting bolts
56.9 - 64.7
5.8 - 6.6
42.0 - 47.7
Propeller shaft mounting bolts
49.0 - 68.6
5.0 - 7.0
36.2 - 50.6
Transfer oil drain plug
39.2 - 58.8
4.0 - 6.0
28.9 - 43.4
Transfer oil filler plug
39.2 - 58.8
4.0 - 6.0
28.9 - 43.4
Hydraulic motor mounting bolt
9.8 - 11.8
1.0 - 1.2
7.2 - 8.7
Pressure sensor mouting bolt
10.8 - 14.7
1.1 - 1.5
7.9 - 10.8

Lubricants
Engine
Items
Specification
Capacity
Diesel 2.2 TCI
Transfer oil
API GL-5, SAE75W/85 Hypoid gear oil
(SK HCT-5 75W85 equivalent)
Filled up to lower filler plug thread level.
0.5L ± 0.0225L
(0.13 U.S gal, 0.52 U.S qt, 0.44 lmp qt) ± (0.01 U.S gal, 0.03 U.S qt, 0.02 lmp qt)
Gasoline 2.5, 3.5 MPI
0.65 L (0.17 U.S.gal, 0.69 U.S.qt, 0.57 lmp,qt)
ALL
Coupling oil
TL7300-SHELL TF0870
0.385ml ± 17.5ml
(0.10 U.S.gal.,0.41U.S.qt,0.34Imp.qt.) ± (0.04 U.S.gal.,0.16U.S.qt,0.13Imp.qt.)

Troubleshooting
Trouble shooting Area of leakage occuring Area Applied engine ① Connecting part/under part of transfer case ② Connecting part of transmission Diesel 2.2 TCI ① Connecting part/under part of transfer ...

Special service tools
Special Service Tools Engine Tools (Number and name) Illustration Use Diesel 2.2 TCI Oil seal installer 09473-D3600 Used for installing the transfer case oil seal (Driveshaft side) (Used with the handle) ...

See also:

Front Door Inside Handle. Repair procedures
Replacement 1. Remove the front door trim. 2. After loosening the mounting screws, then remove the front door inside handle (A). 3. Install in the reverse order of removal. • Make sure the door locks/unlocks ...

Seat cushion height (for driver’s seat)
To change the height of the seat cushion, push the lever upwards or downwards. To lower the seat cushion, push the lever down several times. To raise the seat cushion, pull the lever up several times. ...

If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine may be overheating. If this happens, you should: 1. Pull off the road and stop ...