Hyundai Santa Fe: Button Engine Start System
Seat cushion height (for driver’s seat) Radiator. Repair procedures Rail Pressure Sensor (RPS). Description and Operation
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. 3. Disconnect the connector (B) from the parking assist sensor (A). 4. Pull out the sensor (A) by opening the sensor ...
Parking Assist Sensor. Repair procedures
Component Location 1. Start Stop Button(SSB) 2. FOB key 3. Tailgate open switch 4. RF receiver 5. Interior antenna 1 6. Interior antenna 2 7. Smart key unit 8. Trunk antenna 9. Door handle & door antenna ...
Components and Components
LocationSee also:
To change the height of the seat cushion, push the lever upwards or downwards. To lower the seat cushion, push the lever down several times. To raise the seat cushion, pull the lever up several times. ...
Removal and Installation 1. Disconnect the battery terminals. 2. Remove the air cleaner assembly. 3. Remove the under cover. 4. Loosen the drain plug, and drain the coolant. Remove the radiator ...
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...
