Hyundai Santa Fe: This device complies with Part 15 of the FCC Rules - Rolling code programming - Mirrors - Features of your vehicleHyundai Santa Fe: This device complies with Part 15 of the FCC Rules

Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

WARNING

The transceiver has been tested and complies with FCC and Industry Canada rules. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the device.

NVS® is a registered trademark and Z-Nav™ is a trademark of the Gentex Corporation, Zeeland, Michigan. HomeLink® is a registered trademark owned by Johnson Controls, Incorporated, Milwaukee, Wisconsin.

Erasing HomeLink® buttons
Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink® buttons until the indicator light begins to flash-after 20 seconds. 2. Release ...

Electric chromic mirror (ECM) with HomeLink® system, compass and Blue Link®
Your vehicle may be equipped with a Gentex Automatic-Dimming Mirror with a Z-Nav™ Electronic Compass Display and an Integrated HomeLink® Wireless Control System. During nighttime driving, this feature ...

See also:

High Beam Indicator Light
This indicator light illuminates: When the headlights are on and in the high beam position When the turn signal lever is pulled into the Flash-to-Pass position. ...

ESC Control Module. Repair procedures
Removal 1. Turn the ignition switch OFF. 2. Remove the brake fluid from the master cylinder reservoir with a syringe. • Be sure to completely remove foreign substances from around brake fluid reservoir ...

Alternator. Specifications
Specification Alternator Item Specification Rated voltage 13.5V, 130A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type Regulator Setting Voltage External mode Refer to below ...